best free ip camera software for sunba camera

Set the baud rate to 9600 by setting all switches to the Off position. The SW3 settings are used to set the baud rate that your PTZ camera will use.C-Mor iP Video Surveillance VM Software 5. Set the protocal to PELCO by setting switch #1 to On and the rest of the switches to Off. In this article, we are going to explore a list of 10 best iP camera software for windows. The SW2 settings are used to set the protocol that your camera wil use.If you are setting up more than one PTZ camera on a single system or controller, each camera must have a unique ID so that the controller knows which one you are wanting to comtrol. Do this by setting switch #1 to the On position and the rest of the switches should be set to Off. Assuming that this is the first PTZ that you want your controller to operate, set this camera's ID to 001. The SW1 settings are used to configure the ID of your PTZ camera.Notice that there are 3 difference setting areas: SW1, SW2, SW3. The DIP switches will look like this close up. Once you have the camera outside of the housing, you will see the DIP switches on the top side of the camera as seen below. Download SUNBA Dedicated Pan Tilt Zoom Solution Provider Model 601-D20X V2 (2020 H. BE AWARE, the camera will still be attached to the housing with wires that will not be removed. Carefully remove the camera from the housing.

Best free ip camera software for sunba camera